Help & Support

How to install VDSL on a Raw Copper line

I want to install the modem close to the NTP

1. Make sure NTP 2007 is installed at the entry point in your house/apartment.

2. Connect your modem/router to the NTP with a DSL/internet cable. 

  • Insert the cable into the DSL/WAN port on the modem/router.
  • Insert the free end of the cable into the free port on the NTP.
How to install VDSL on a Raw Copper line

 

3. Connect the power supply unit of your modem/router to the port on your modem/router labeled “POWER” or “PWR”.

How to install VDSL on a Raw Copper line

 

4. Plug the other end of the power supply into an AC power outlet.

5. Check if the DSL LED starts flashing.

NOTE! In case your VDSL signal is already activated, after some minutes the DSL LED should become stable.  It means your modem/router is now receiving the VDSL signal.

 

How to install VDSL on a Raw Copper line

 

I want to install the modem on another phone socket

1. Make sure NTP 2007 is installed at the entry point in your house/apartment.


2. Connect your other phone socket to the blue connector inside the NTP by means of a separate cable used only for a modem/router connection. This is an ordinary phone cable (a VVT-cable or a less preferable UTP-cable) that can be bought at any electrical shop.

How to install VDSL on a Raw Copper line

 

3. Install a VDSL2-splitter on all your phone sockets including the NTP. 

How to install VDSL on a Raw Copper line

 

NOTE! Make sure the switches on your VDSL splitter are in the ON-position.

How to install VDSL on a Raw Copper line

4. Connect your modem/router to the phone socket with a DSL/internet cable. 

  • Insert the cable into the DSL/WAN port on the modem/router.
  • Insert the free end of the cable into the free port on the phone socket or a splitter.
How to install VDSL on a Raw Copper line

5. Connect the power supply unit of your modem/router to the port on your modem/router labeled “POWER” or “PWR”.

How to install VDSL on a Raw Copper lineHow to install VDSL on a Raw Copper lineHow to install VDSL on a Raw Copper line

 

6. Plug the other end of the power supply into an AC power outlet.

7. Check if the DSL LED starts flashing.

NOTE! In case your VDSL signal is already activated, after some minutes the DSL LED should become stable.  It means your modem/router is now receiving the VDSL signal.

 

How to install VDSL on a Raw Copper line

 

edpnet cookies

Functional (necessary) and analytical cookies are recommended for our edpnet website to work properly. They are not used to identify you as a visitor on our website. Edpnet also uses commercial/advertising cookies which are used to personalize advertisements on third party websites. These cookies are by default disabled. But you can choose to enable them below. Visit our Cookie Policy for details.

Settings
Commercial/advertising cookies are used to personalize advertisements. The intention is to display edpnet advertisements, which are relevant and attractive to the individual user, on third party websites. You can read who these third parties are in our Cookie Policy.
Accept recommended cookies