Help & Support

Find an answer to your question

How do I configure my Fritz!Box 7490 in bridge mode

With this manual, you will be able to put your Fritz!Box 7490 in bridge mode. It will force the device to only act as a modem, letting you configure PPP connection on your own device connected behind.

NOTE! This guide is only applicable if you are using the Fritz!Box on VDSL line.


Download the configuration File

You will need a special configuration file to import into your device.

Download the configuration file (right-click on the link and click ‘save as’)

Navigate to the correct page

Open your web browser (Internet Explorer, Firefox,…) and go to the web interface of your Fritz!Box. By default, it should be reachable on or Log into the device if you are prompted to, then go to System and click on Backup option in a drop-down menu:

Then click on Restore tab:

Upload the configuration file

Browse to the configuration file you previously downloaded and fill in the password, which is ‘avm’ (without the quotes, case sensitive). Now press Restore and follow the instructions shown on the screen. After that is done, your Fritz!Box will reboot and you will be automatically redirected to the Overview page.

Connect your local network

No further configuration of your device is needed. Once the reboot is completed, just connect a network cable from the port LAN4 of your Fritz!Box to your internal network. PPP configuration is to be done on the authenticating device.

NOTE! Once the bridge mode is enabled, only the port LAN4 will remain active.


Posted on Dec 22, 2017 | Tags:

I didn't find my answer

Contact details

  • Edpnet NV
    Van Landeghemstraat 20
    9100 Sint-Niklaas
  • Opening hours: Mon-Fri, 9AM till 5PM
  • 03 265 67 00
  • Mediation service